Lovely by Deanna Wentz

Art Rubber Stamp from Stampsmith.net

Directions:
Fold 8-1/2” black tag in half with bone folder.
Stamp image onto cardstock and tear edges on all four sides.
Rip 7gypsies’ word paper in aprox. 1” strip.
Center and mount image onto front side of folded tag. Mount paper strip diagonally across image to the edges of the tag.
Apply rub-on word to small circle tag. Pierce hole in black tag and adhere circle tag with brad.
Use screw punch to place hole in backside of tag (lined up with front hole). Use white ribbon as tag card closure

Mother's Day Bouquet by Chriss Grabb

Art Rubber Stamp from Stampsmith.net

Directions:
Stamp Girl image on glossy paper with purple chalk ink.
Allow to dry and then trim closely.
Color the flowers in the basket with yellow Sharpie. Set aside.
Stamp Girl image on acetate with Black StazOn ink. Allow to dry.
Trim acetate 1/4" outside of image and align on top of purple stamped image.
Attach with vellum tape. Set aside.
Trim flowered paper to 4" x 5 1/4" and attach to folded yellow card. Set aside.
Punch a hole in each corner of the prepared stamped image. Attach yellow eyelets.
Thread ribbon through top eyelets and tie into bow.
Adhere image to flowered paper on prepared card.

A Lacy Mother’s Day by Sue Lorang

Art Rubber Stamp from Stampsmith.net

Directions:
1. Stamp the image onto glossy white cardstock. Center the Coluzzle tag over the image, then using the mat and knife, cut out the tag.
2. Crumple up the cream cardstock, flatten it out and run the ochre color stamp pad over the cardstock catching the high spots. Wet the cardstock with a water mister and the color will run a little. Put it between two pieces of paper and iron it till flat.
3. Cut out 1/4 of the doily, and then position it onto the antiqued cardstock you just made. When you like the way it looks take an adhesive to attach it to the cardstock. After it’s dry, cut off the excess doily material.
4. Position the vellum at an angle on the bottom part of the cardstock over the tag. Use vellum tape on the back to stick it down.
5. Center the antiqued cardstock onto the gold Bazzill paper and attach.
6. Adhere the floral brass embellishment at the bottom.

Mother's Day Flapper card by Betty McCommon

Art Rubber Stamps from Stampsmith.net
Greeting by TAC

Directions:
Stamp flapper lady on white cardstock with Purple Versafine ink.
Cut out with deckle scissors. Attach silver corner stickers.
Stamp Cartolina postal with Black Brilliance ink on Vellum. Tear around this image.
Stamp corner flower from China plate with red ink on purple cardstock.
The Mother’s Day greeting is stamped on Muslin with purple Versafine and cut out.
The heart is plastic so I colored it with the silver Krylon pen. Assemble as shown.
Punch a hole in the top of purple cardstock before you glue to white base and thread the fibers through.

Happy Mother’s Day by Heather Taylor

Morning Glory stamp & 3 irises stamp by Art Neko
"Happy Mother's Day" stamp (off the Silhouettes sheet) by About Art Accents

Instructions:
Stamp the items on white cardstock (4 x 5.25") and emboss.

Stipple inks onto the card. Use a slightly damp paper towel to wipe off the embossing so it remains very black. You can also use the paper towel to smooth out the colors on the card.

Moisten your toothbrush and run a line of Gold Rush reinker down the middle. Use your finger to slide down the bristles and splatter the cardstock. If you don't like the pattern, you can always smooth out the mistakes with that damp paper towel.

Using the slightly damp paper towel, dip it into the PearlEx and rub all over the card until it gets a nice sheen.

With 4 strips of Magic Tape on the back, attach the panel to a 5.5" x 8.5" piece of glossy black cardstock that you've folded in half.

Mother’s Day Tea by Sue Lorang

Art Rubber Stamps from Stampsmith.net

Directions:
1. Stamp the image on glossy paper in brown. Cut around the image and punch the corners.
2. Take a piece of glossy and rub some brown Marvy on it (direct to paper). Stamp the saying with gold and emboss it with gold. Cut to 1½ X 3¼ and punch the corners.
3. Adhere the stamped images as shown onto the printed paper. Center and adhere to the deep aqua.
4. Poke a small hole in the top left corner of the stamped image. Using a floss threader, thread the fibers through the hole in the charm and then through the hole in the card. Tape the fibers to the back of the card.
5. Adhere the card front to the copper Stardream paper.